HP 706C Manuel d'utilisateur télécharger pdf (Page 69)

If you do not have a dumb terminal or a terminal emulation program,

BayTech supplies a utility diskette which includes software to put an

IBM PC or compatible into a terminal mode. See

Section 4.2

for

instructions to obtain the software (TERM.EXE) by running the

INSTALL.EXE program if you have not already done so.

Once you have obtained TERM.EXE, use the following procedure:

1. From the BAYTECH subdirectory prompt enter:

term



The program will respond with an identification block

and configuration menu for the PC COM port similar to

the following:

You are now in the terminal emulation mode with full

duplex communication. Any characters you type from

the keyboard will be transmitted out of the PC COM port

to Print Master. They will not appear on the CRT

screen. Any characters received from Print Master by

the PC COM port will be displayed on the CRT screen.

2. Ensure the displayed PC Configuration is correct. If not,

enter ALT-C to change. For example, if you have your

serial cable physically connected to COM2 on your PC,

first type ALT-C followed by the up arrow key and then

<ENTER> to have the TERM program switch to COM2.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 122 123

Pas de commentaire

HP 706C Manuel d'utilisateur Page 69