HP J3188A Manuel d'utilisateur télécharger pdf (Page 13)

1-3

Installing the Hub

Installing and Configuring Your Hub

Installing the Hub

1. Plug the power cord into the hub’s power cord receptacle and into an AC

(alternating current) power source. If you are using an RPS as your

primary power source, refer to the Cisco RPS User Guide for specific

instructions.

Note If your RPS is the primary power source for the hub, disconnect the AC power

cord connected directly to the hub for proper operation.

Note The hub does not have a power switch; it is powered on when the power cord

is plugged in. HP recommends that you only use one power source at a given

time.

If not connecting a Redundant Power Supply,

connect included power cord here and to an

alternating current power source.

(Optional) Connect Redundant Power Supply connector

cord clip here.

MUCHO.BK : ch1.fm5 Page 3 Thursday, June 26, 1997 11:37 AM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 99 100

Pas de commentaire

HP J3188A Manuel d'utilisateur Page 13