HP HSC/PCI 1000Base-SX Manuel d'utilisateur télécharger pdf (Page 35)

Troubleshooting

Diagnostic Flowcharts

Chapter 4

Flowchart 2 Procedures

• Execute linkloop(1M) to remote host. If linkloop is successful, continue to Network

Level Tests. Otherwise, note which error was returned.

• If loopback failed error = “Address has bad format” or “Not an individual address,”

correct link level address with proper station address format/value and repeat Link

Level Test.

• Otherwise, loopback failed because remote host did not respond. Double check

remote host address or choose another remote host and re-execute linkloop(1M).If

linkloop is successful, continue to Network Level Tests. You may also want to call the

node manager of the remote host that did not respond (if this was the case). If

linkloop fails, go to Conﬁguration Tests.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 80 81

Pas de commentaire

HP HSC/PCI 1000Base-SX Manuel d'utilisateur Page 35