HP HSC/PCI 1000Base-SX Manuel d'utilisateur télécharger pdf (Page 53)

Troubleshooting

Diagnostic Flowcharts

Chapter 4

Flowchart 6c Procedures

• Execute ifconfig(1M) on the interface you want to conﬁgure to ensure that

interface is enabled. Example:

ifconfig lan1 192.6.1.17 netmask 255.255.255.0 up

Next, execute ifconfig

interface

to test and verify ﬂag setting is UP and correct

IP address is displayed. Example:

ifconfig lan1

<UP,BROADCAST,RUNNING,MULTICAST,CKO>

• If IP and ﬂags are correct, verify there is an entry for card interface in

/etc/rc.config.d/netconf. If so, go to Network Level Tests. Otherwise, add

correct interface parameters to /etc/rc.config.d/netconf file and reboot. If

ﬂags are incorrect, correct them with ifconfig and repeat ifconﬁg Test. Otherwise,

if ifconfig is not successful and error messages appear, correct them accordingly

and repeat ifconﬁg Test.

• If you cannot correct errors, call your HP representative.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 80 81

Pas de commentaire

HP HSC/PCI 1000Base-SX Manuel d'utilisateur Page 53