HP NetServer LH 3/LH Guide d'installation télécharger pdf (Page 23)

Chapter 1 Processor Module Installation

Setting the Processor Speed Switches

After installing processors, verify that the processor speed switches are set

correctly. If the switches are not set correctly, set them accordingly.

NOTE If two processors are installed in the NetServer, both must be

the same speed.

To set the processor speed switches:

1. Locate the switches and the switch chart at the upper right corner of the

system board (see Figure 1-9).

2. Look up the appropriate switch settings (located on the chart adjacent to

the switches) for the processor module(s) installed in the NetServer.

3. Set the switches accordingly.

CAUTION Processor modules are designed to operate at only one speed.

This speed is printed on the module. Do not set the processor

speed switches to any speed other than that speed labeled on

the module. Setting the processor speed to another speed may

result in unreliable or intermittent performance. Data

integrity may also be placed at risk if processors are operated

at speeds other than that specified on the processor module.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Pas de commentaire

HP NetServer LH 3/LH Guide d'installation Page 23