HP Visualize b2000 - Workstation Spécifications télécharger pdf (Page 114)

114 Chapter4

Changing Your Workstation’s Hardware Conﬁguration

Removable Media Devices

7. Tighten the two ﬂoppy disk bracket screws as shown in Figure 4-34.

Figure 4-34 Tightening the Bracket Screws

8. Make sure that the ﬂoppy data and power cables are positioned so

that they come out of the top edge of the rear ﬂoppy disk drive bay’s

cover. This edge is rounded to prevent cutting of the cables. See

Figure 4-35. Put the rear cover in place and tighten the T-15

Torx/slotted screw.

Figure 4-35 Replacing the Rear Floppy Disk Drive Bay’s Cover

9. Replace the plastic ﬂoppy disk drive blank in the workstation’s front

Bracket Screw

T-15

Torx/slotted

Screw

Power

Cable

Rear Cover

Data Cable

Rear Cover Handle

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 228 229

Pas de commentaire

HP Visualize b2000 - Workstation Spécifications Page 114