HP Visualize c240 - Workstation Manuel de service télécharger pdf (Page 71)

Using Your Digital Data Storage (DDS) Tape Drive

Operating the DDS Tape Drive

Archiving Data

This section describes how to transfer data to and from a DDS-format data

cassette (saving and restoring) using the HP-UX tar command and your tape

drive’s device ﬁle.

The tar command allows you to save ﬁles to a data cassette, restore ﬁles

from a data cassette to your system, or list the ﬁles on your data cassette.

Writing to a Data Cassette

Use the following instructions to save ﬁles to a data cassette:

1 Check that the write-protect tab on the data cassette is in the write position.

2 Load the data cassette into the tape drive.

3 In a terminal window, enter the following command line to write to the tape:

tar -cvf /dev/rmt/devicefile pathname

where devicefile is one of the device ﬁles listed from sam and pathname is the

pathname of the ﬁle or directory containing ﬁles that you want to write to the

tape. To use the data compression mode, use one of the device ﬁle names that

sam listed as supporting compression.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 239 240

Pas de commentaire

HP Visualize c240 - Workstation Manuel de service Page 71