HP Visualize c3000 - Workstation Manuel d'instructions télécharger pdf (Page 127)

Chapter 4 127

Field Replaceable Units

FRU Removal and Replacement

Speaker

This section explains how to remove and replace the speaker in the B2000 workstation.

The speaker is contained in the mounting bracket with the I/O fan. See Figure 4-53.

Figure 4-53. Location of the Speaker

Removing the Speaker

Perform the following steps to remove the speaker:

1. Open the left side panel of the workstation as shown in the section “Opening the Left

Side Panel.”

2. Remove the PCI retainer clip and all I/O cards. See the section “Removing I/O Cards” on

page 111.

3. Unscrew the two T-15 Torx screws that hold the workstation’s air divider in place, as

shown in Figure 4-54. Then grasp the edge of the air divider and pull it towards you to

remove it from the workstation.

Figure 4-54. Removing the Air Divider

Speaker

T-15 Torx

Air Divider

Screw

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 203 204

Pas de commentaire

HP Visualize c3000 - Workstation Manuel d'instructions Page 127