HP Visualize c3000 - Workstation Manuel d'instructions télécharger pdf (Page 98)

98 Chapter 4

Field Replaceable Units

FRU Removal and Replacement

If you will replace the floppy disk drive with a blank, continue on with step 7 below.

However, if you will replace it with a new floppy disk drive, go to step 6 in the section

“Replacing or Installing a Floppy Disk Drive” on page 101.

7. Place the floppy disk drive blank in the floppy disk drive bracket and tighten the four

floppy disk drive mounting screws (T-15 Torx/slotted screws) into the bracket. See

Figure 4-15.

Figure 4-15. Installing the Floppy Disk Drive Blank and Bracket

8. Slide the floppy disk drive blank and its bracket into the workstation chassis as shown

in Figure 4-15.

9. Tighten the two floppy disk drive bracket screws as shown in Figure 4-16.

Figure 4-16. Tightening the Bracket Screws

Floppy Disk Drive

Mounting Screws

Floppy Disk

Floppy Disk Drive

Mounting Screws

Drive Blank

Floppy Disk

Drive Bracket

Bracket Screw

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 203 204

Pas de commentaire

HP Visualize c3000 - Workstation Manuel d'instructions Page 98