HP Workstation Z210 CMT Spécifications télécharger pdf (Page 103)

3. Remove the expansion card retainer (if installed): grasp the top of the clamp (1), squeeze the

release handles until the bottom of the clamp releases from the clamp rail (2) (it should click when

it releases), and swing the clamp out from the back panel (3).

Figure 5-29 Removing expansion card retainer

4. Remove all cables connected to the expansion card.

5. Push down on the expansion card retention clamp levers on the inside of the chassis to open the

retention clamp (1) as shown below.

Figure 5-30 Removing the expansion card

6. If the card is in one of the slots with a latch, release the latch (2). (Note that there are two different

styles of latch.)

ENWW

Removing and installing components

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 184 185

Pas de commentaire

HP Workstation Z210 CMT Spécifications Page 103