HP xw6000 Guide de l'utilisateur télécharger pdf (Page 2)

System board connectors (continued)

Installing an Additional Processor

IMPORTANT: If the system board part number in your workstation is 339100-xxx, this section replaces

the “Installing an Additional Processor” section of the existing Hardware Reference Guide.

CAUTION: Failure to follow the workstation preparation instructions and these installation steps could

result in an improperly installed processor, causing extensive system damage.

NOTE: The second processor must be of the same speed, cache, size, and type as the primary processor.

To install a second processor:

1. Power down your system as instructed in the Hardware Reference Guide.

2. Remove the workstation access panel.

3. Place the workstation in the desktop position.

CPU power connector

CD-ROM audio connector

Power button/LED connector

Auxiliary audio connector

Diskette drive connector

Battery

Primary ATA connector

Password jumper

SCSI connector

CMOS reset switch

Hood sensor connector

PCI sockets

Front USB connector

Front audio connector

Secondary ATA connector

AGP socket

Front chassis fan connector

DIMM sockets

Internal speaker connector

24-Position power connector

1 2 3 4 5 6 7 ... 82 83

Pas de commentaire

HP xw6000 Guide de l'utilisateur Page 2