HP xw6000 Guide de l'utilisateur télécharger pdf (Page 42)

2–14 Hardware Reference Guide

Hardware Upgrades

Locating the Hardware Screws

Your workstation has extra guide screws stored behind the front bezel.

Install these screws to ensure that the drive lines up correctly in the

drive bay. Some options use M3 metric hardware. HP supplied metric

screws are black.

Identifying the guide screws

Installing a Hard Drive

The following sections provide instructions for installing a hard drive

into a 3.5-inch drive bay and into a 5.25-inch drive bay.

Installing a Hard Drive into a 3.5-Inch Drive Bay

✎

Prior to installing a SCSI device, read the section “SCSI Devices” in

Appendix B.

To install a hard drive into a 3.5-inch drive bay:

1. Shut down the operating system properly, then turn off the

workstation. Disconnect the power cord from the grounded

AC outlet.

2. Remove the workstation access panel. See “Removing the

Workstation Access Panel” in this chapter.

3. Remove the front bezel. See “Removing the Front Bezel” in this

chapter.

Longbow.book Page 14 Thursday, August 22, 2002 11:38 AM

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 82 83

Pas de commentaire

HP xw6000 Guide de l'utilisateur Page 42