HP 2000CP 2500CP Manuel d'utilisateur télécharger pdf (Page 300)

Removal and Installation

8-79

HP DesignJet CP Series Printers

Installation

1. Carefully push the media sensor assembly (item 1) onto the retaining pin

located underneath the entry platen.



Care should be taken while performing the following

procedure, the entry platen has sharp edges and

could cause injury.

Note: On the inside of the left and right hand side chassis,

there are locating pins (item 4). The correct locating pin for

the entry platen is located just below the starguard assembly.

2. Install the entry platen (item 2) onto the entry platen locating pins

(item 4).

Caution: Be careful not to drop the entry platen. Support the

entry platen throughout the next step.

3. Install two T-15 screws (item 5) into the right hand side chassis securing

the entry platen.

4. Install two T-15 screws (item 3) securing the entry platen to the left

hand side of chassis.

5. Install the top half of the elevator assembly by securing it with two

retaining clips at the back and push down and to the right.

6. Connect the media sensor cable to the electronics module in position J6

MEDIA.

7. Install the media sensor cable in the cable clamp at the rear of the

printer.

8. Install the following:

1. Right Hand Cover  page 8-21.

2. Left Hand Cover  page 8-18.

3. Window and Top Cover  page 8-15.

9. Connect the power cord and turn the printer on in service mode.

10.Perform D08 Sensor Service Test  page 4-31

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 347 348

Pas de commentaire

HP 2000CP 2500CP Manuel d'utilisateur Page 300