HP 2000CP 2500CP Manuel d'utilisateur télécharger pdf (Page 49)

2-14 System Error Codes

HP DesignJet CP Series Printers

System Error: 010039

Problem Description: A Printhead voltage could not be set - Carriage

PCA Failure

Corrective Action: Try the following:

D Make sure that the Trailing Cable is connected

correctly.

D Replace the Trailing Cable ' page 8-36.

D Replace the Carriage Assembly ' page 8-42.

Only replace one component at a time and

check if the error has gone before replacing

another component. Using this procedure

you will be able to determine exactly which

component failed.

System Error: 010040

Problem Description: The Ambient Temperature measured is out of the

normal range.

Corrective Action: Try the following:

D Make sure that the Trailing Cable is connected

correctly.

D Replace the Trailing Cable ' page 8-36.

D Replace the Carriage Assembly ' page 8-42.

D Replace the Electronics Module ' page 8-6.

Only replace one component at a time and

check if the error has gone before replacing

another component. Using this procedure

you will be able to determine exactly which

component failed.

System Error: 010041

Problem Description: Problem in setting the Printhead Voltage.

Corrective Action: Switch the Printer OFF and ON again. During

initialization another error code will appear. Refer

to the relevant error code for further information.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 347 348

Pas de commentaire

HP 2000CP 2500CP Manuel d'utilisateur Page 49