HP 61-in Manuel d'utilisateur télécharger pdf (Page 51)

Unload a roll from the take-up reel

On the printer's front panel, select the

icon, then select Take-up reel > Disable take-up

reel.

The printer advances the substrate to allow for cutting.

2. Switch the wind-direction switch to the off position. The switch is in the off position when it is

centered (in other words, when the switch is neither in position 1 nor position 2).

3. Remove the loop-shaper. If you omit this step, it will fall to the floor with the substrate when the

substrate is cut.

To remove the heavy loop-shaper, first lift the support, then press the lever.

ENWW

The take-up reel

Handle the substrate

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 94 95

Pas de commentaire

HP 61-in Manuel d'utilisateur Page 51