HP CH336A#B1K Manuel d'utilisateur télécharger pdf (Page 34)

System Error Codes

2-7

HP DesignJets 500, 510 and 800 Series Printers Service Manual

System Error: 01:10

Problem

Description:

Electronics Module failure. The possible cause could be:

1. The Electronics Module is of the wrong type (a 16 MB

Electronics Module will not work in a 24" Model).

2. Reading, writing or initializing the EEROM failed.

3. One of the ASIC’s was not found within the Serial Bus that

connects the Electronics Module to the Carriage Assembly.

4. One of the ASIC’s did not respond to the Serial Bus that connects

the Electronics Module to the Carriage Assembly.

5. The Electronics Module is requesting a move to the Service

Station while the previous move is still being completed.

6. The Electronics Module Cooling Fan has reached its current

limit.

Corrective Action: Replace the Electronics Module ⇒ Page 8-24.

System Error: 01:11

Problem

Description:

The Electronics Module Cooling Fan badly connected.

Corrective Action: Reconnect the Cooling Fan (located on top of the Electronics

Module). If the Cooling Fan continues to fail, check that the

connector pins in the Electronics Module are NOT bent.

System Error: 01:12

Problem

Description:

The EEROM is not configured correctly (the product number may

be missing).

Corrective Action: Configure the EEROM correctly using the EEROM setup utility ⇒

Page 4-17.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 284 285

Pas de commentaire

HP CH336A#B1K Manuel d'utilisateur Page 34