HP D5400 Manuel d'utilisateur télécharger pdf (Page 161)

11. Reinstall the ink cartridge.

It should now snap down into place.

12. Close the ink cartridge access door, and check if the error message has gone

away.

13. If you still receive the error message, turn the product off, and then on again.

Cause: The indicated ink cartridges were not installed correctly.

If this did not solve the issue, try the next solution.

Solution 2: Clean the electrical contacts

Solution: Clean the electrical contacts.

CAUTION: The cleaning procedure should take only a few minutes. Make sure

that the ink cartridges are reinstalled in the product when instructed. Leaving them

outside of the product for an extended period of time can result in damage to the

ink cartridges.

To clean the electrical contacts

1. Make sure the product is turned on.

2. Open the ink cartridge access door by lifting from the front right of the product,

until the door locks into place.

Chapter 11

160 Troubleshooting

Troubleshooting

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 220 221

Pas de commentaire

HP D5400 Manuel d'utilisateur Page 161