HP Hybrid POS Printer with MICR II Manuel d'utilisateur télécharger pdf (Page 20)

●

Indicate Yes with a long click. (Press and hold the paper feed button for more than one second.)

●

Indicate No with a short click. (Press the paper feed button quickly.)

5. Continue through your menu selections until you are prompted, Save New Parameters?.

If you want to save, select Yes. Then press the reset button. The printer resets with the new selections.

You can verify the setting by pressing the paper feed button to print out a diagnostics form or by holding

the paper feed button and opening and closing the receipt cover.

–or–

If you want to continue conguring the printer, select No. The printer returns to the conguration menu

where you can set parameters again.

Changing diagnostic modes

To change the diagnostic modes, enter the conguration menu. Refer to Conguring the printer on page 13

for instructions on how to enter the conguration menu. Select Set Diagnostic Modes from the main menu

and select one of the following modes:

●

Normal—Normal operating mode of the printer.

●

Data scope—The receipt printer prints incoming commands and data in hexadecimal format to help

troubleshoot communication problems.

●

Receipt test—The receipt printer prints two code pages to verify proper printing of the receipt.

●

Slip test—The slip printer prints two code pages to verify the slip printer is operating properly.

●

MICR test mode—The receipt printer prints all characters recognized by the check reader to verify that

the printer is properly reading a check inserted in the slip.

Enabling or disabling data scope mode

The data scope mode test prints a hexadecimal dump of all data sent to the printer. Hexadecimal code is a

base 16 numeric system used in computing, where the letters A through F are used for numbers 10 through

15. Your technical sta can use hex code to troubleshoot communication problems.

You can enable and disable data scope mode by selecting the Diagnostic Modes submenu of the

conguration menu.

Press the paper feed button as instructed on the Diagnostic Modes Menu to enable or disable the data scope

mode test.

14 Chapter 2 Setting up the printer

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 44 45

Pas de commentaire

HP Hybrid POS Printer with MICR II Manuel d'utilisateur Page 20