HP StorageWorks Enterprise File Services WAN Accelerator Guide de l'utilisateur télécharger pdf (Page 48)

42 5 - CONFIGURING CONNECTION FORWARDING

You can configure connection forwarding using the Management Console or the HP

EFS WAN Accelerator command-line interface (CLI).

Configuring

Connection

Forwarding

Using

the

Management

Console

The following section describes the basic steps for enabling and configuring

connection forwarding using the Management Console.

The following figure illustrates a network deployment in which the packets from the

client to the server go through HP EFS WAN Accelerator-2 while packets from the

server to the client go through HP EFS WAN Accelerator-3. From HP EFS WAN

Accelerator-3 the packets are sent to HP EFS WAN Accelerator-2, through the virtual

path.

Figure 5-3. Connection Forwarding in an Asymmetric Network

IMPORTANT: When you define a neighbor, you must specify the HP EFS WAN Accelerator

in-path IP address, not the primary IP address.

Basic Steps

(Client-Side)

Perform the following step on each of the client-side HP EFS WAN Accelerators.

• The client-side HP EFS WAN Accelerator is configured as an in-path device. For

detailed information, see the HP StorageWorks Enterprise File Services WAN

Accelerator Installation and Configuration Guide.

Basic Steps

(Server-Side)

Perform the following steps on each of the server-side HP EFS WAN Accelerators.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 123 124

Pas de commentaire

HP StorageWorks Enterprise File Services WAN Accelerator Guide de l'utilisateur Page 48