HP StorageWorks Enterprise File Services WAN Accelerator Guide de l'utilisateur Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 104
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
20 1 - OVERVIEW OF THE HP EFS WAN ACCELERATOR
To remove the version
configuration from the
HP EFS WAN
Accelerators
1. Connect to the Management Console on each HP EFS WAN Accelerator.
2. Install the v2.1 image in the Setup: Software Upgrade page.
3. Save the current configuration in the Setup: Configuration Manager page.
4. Reboot the HP EFS WAN Accelerator in the Setup: Reboot Appliance page.
5. Connect to the CLI on each of the HP EFS WAN Accelerators you originally
upgraded (that is, HP EFS WAN Accelerator-1, HP EFS WAN Accelerator-2, HP
EFS WAN Accelerator-3, HP EFS WAN Accelerator-4).
6. On HP EFS WAN Accelerator-1, at the system prompt, enter the following set of
commands:
SH1 > enable
SH1 # configure terminal
SH1 (config) # no peer 0.0.0.0
SH1 (config) # no peer <HP EFS WAN Accelerator-2 IP addr>
SH1 (config) # no peer <HP EFS WAN Accelerator-3 IP addr>
SH1 (config) # no peer <HP EFS WAN Accelerator-4 IP addr>
SH1 (config) # write memory
SH1 (config) # restart
7. On HP EFS WAN Accelerator-2, at the system prompt, enter the following set of
commands:
SH2 > enable
SH2 # configure terminal
SH2 (config) # no peer 0.0.0.0
SH2 (config) # no peer <HP EFS WAN Accelerator-1 IP addr>
SH2 (config) # no peer <HP EFS WAN Accelerator-3 IP addr>
SH2 (config) # no peer <HP EFS WAN Accelerator-4 IP addr>
SH2 (config) # write memory
SH2 (config) # restart
8. On HP EFS WAN Accelerator-3, at the system prompt, enter the following set of
commands:
SH3 > enable
SH3 # configure terminal
SH3 (config) # no peer 0.0.0.0
SH3 (config) # no peer <HP EFS WAN Accelerator-1 IP addr>
SH3 (config) # no peer <HP EFS WAN Accelerator-2 IP addr>
SH3 (config) # no peer <HP EFS WAN Accelerator-4 IP addr>
SH3 (config) # write memory
SH3 (config) # restart
9. On HP EFS WAN Accelerator-4, at the system prompt, enter the following set of
commands:
SH4 > enable
SH4 # configure terminal
SH4 (config) # no peer 0.0.0.0
SH4 (config) # no peer <HP EFS WAN Accelerator-1 IP addr>
SH4 (config) # no peer <HP EFS WAN Accelerator-2 IP addr>
SH4 (config) # no peer <HP EFS WAN Accelerator-3 IP addr>
SH4 (config) # write memory
SH4 (config) # restart
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 103 104

Commentaires sur ces manuels

Pas de commentaire