HP D2200sb Manuel d'utilisateur télécharger pdf (Page 12)

Operations 12

To remove the component:

1. Power down the partner server blade (on page 9).

2. Remove the storage blade (on page 10).

3. Press the access panel release button.

4. Slide the access panel toward the rear of the storage blade.

5. Remove the access panel.

Install the access panel

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION: To prevent damage to electrical components, properly ground the server blade

before beginning any installation procedure. Improper grounding can cause ESD.

CAUTION:

Do not operate the storage blade with the access panel open or removed. Operating

the storage blade in this manner results in improper airflow and improper cooling that can lead

to thermal damage.

To install the component:

1. Place the access panel on top of the storage blade. Allow the panel to extend past the rear of the

storage blade approximately 0.8 cm (0.2 in).

2. Slide the access panel toward the front of the storage blade. The access panel locks into position.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 48 49

Pas de commentaire

HP D2200sb Manuel d'utilisateur Page 12