HP SP400 Guide de l'utilisateur télécharger pdf (Page 18)

Set up the All-in-One

7. Tighten the finger strap by pulling straight up from the buckle until there is no movement

between the hand and the All-in-One and then secure the fastener ends to lock the finger strap

in place.

IMPORTANT: The finger strap must be tight enough to prevent motion between the fingers and

the All-in-One because under-tightening may lead to irritation. Do not over-tighten to the point that

numbness or discomfort results.

NOTE: To loosen the finger strap, release the fastener strap and rotate the buckle outwards until

it is at a 90-degree angle to the All-in-One, as shown in step #1. Then pull the strap with your

fingers until it is comfortable.

8. To tighten the wrist strap, bend the wrist upward while making a relaxed fist, and then pull the

strap until the All-in-One makes light contact with the knuckles. Light tension is sufficient.

CAUTION: Do not over-tighten the wrist strap. It should not create pressure on the knuckles.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 65 66

Pas de commentaire

HP SP400 Guide de l'utilisateur Page 18