HP ProLiant ML370 Generation 5 Spécifications télécharger pdf (Page 43)

Removal and replacement procedures 43

To replace the component, reverse the removal procedure.

Media blanks

To remove the component:

1. Power down the server (on page 29).

2. Open or remove the tower bezel ("Front bezel" on page 30).

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays

are populated with either a component or a blank.

3. Remove the media blanks.

NOTE: HP recommends that you remove all media blanks to facilitate drive installation.

Retain the blanks for future use.

To replace the component, reverse the removal procedure.

Half-height or full-height media devices

To remove the component:

1. Power down the server (on page 29).

2. Do one of the following:

• Unlock and remove the bezel ("Front bezel" on page 30).

• Extend the server from the rack (on page 29).

3. Remove the access panel ("Access panel" on page 31).

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 96 97

Pas de commentaire

HP ProLiant ML370 Generation 5 Spécifications Page 43