HP Server tc2110 Guide de l'utilisateur télécharger pdf (Page 37)

Chapter 3 Installing and Configuring

Figure 3-12. DIMM Locations on System Board

6. Remove the new DIMM from its container, handling the module by its edges.

Use only HP PC133 (133 MHz) unbuffered ECC SDRAM DIMMs.

CAUTION The DIMM should be left in the anti-static container or placed on an anti-static surface,

until you are ready to install it into the DIMM slot.

7. Spread the two retaining latches on the slot and align the notches on the DIMM with the keys on the

slot. See Figure 3-13.

Figure 3-13. DIMM to Slot Alignment

8. Holding the DIMM at 90 degrees to the system board, press the DIMM fully into the slot until the

retaining latches close. See Figure 3-14.

If the latches do not close, the DIMM is not inserted correctly.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 117 118

Pas de commentaire

HP Server tc2110 Guide de l'utilisateur Page 37