HP Server tc2110 Guide de l'utilisateur télécharger pdf (Page 95)

Chapter 7 Replacing Parts

3. Remove the slot cover latch by:

a. Lifting up on the tab of slot cover latch with your finger.

b. Raise the slot cover latch up away from the slot covers.

c. Remove it from the chassis and keep it for reassembly later.

You may need to lift the slot cover latch out of its retainer before lifting it out of the chassis to

remove the slot cover latch.

4. Select the desired accessory slot cover, slide the top of the slot cover away from the chassis, and then lift

it up and out of the chassis as shown in the following illustration.

5. Slide the accessory board into the desired PCI slot and then press down to seat the board.

6. Ensure the accessory board is seated properly in the PCI slot.

Slot Cover

Figure 7-15. Removing the Slot Cover

Figure 7-16. Inserting an Accessory Board

7. Replace the slot cover latch to ensure the accessory board is held in place.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 117 118

Pas de commentaire

HP Server tc2110 Guide de l'utilisateur Page 95