HP VMA-series Memory Arrays Manuel d'utilisateur télécharger pdf (Page 59)

Connecting to the CLI

HP-AM456-9002A Rev 01

VMA-series Memory Array Installation and Service Guide

Connecting to the CLI

Logging into the CLI via the Serial Interface

Access the Command Line Interface (CLI) through the serial connection between

the host computer and the Memory Array. This connection was set up when the

equipment was installed into its permanent location. See Connecting the Serial

Cable on page 50.

See Table 3.4 on page 50 for the serial interface default values.

Note: Your settings for the console connection may vary from the listed

default settings.

Note: Use a USB-to-serial adapter to plug into the serial port on the back of

the Memory Array if your host computer does not have an available serial port.

Logging in via a Windows host computer

The following procedure shows how to connect to the Memory Array using a

terminal emulation application. For example, using PuTTY to connect to the CLI

through the serial connection:

1. Log into the host computer as an administrator.

2. From the Windows Start menu, select Programs > Accessories >

Communications > PuTTY.

The

New Connection - PuTTY1

window opens.

3. In the

Connection Description

window:

a. Type the name of the new connection in the Name field.

b. Select the appropriate icon from the list of available ones.

c. Click OK when done.

The

Connect To

window opens.

4. In the Connect using drop-down list, select Serial.

5. Click Connect.

The following login prompt appears:

6. Type the default login name (admin) and password (admin) to log into the

system.

You are now connected to the CLI of the Memory Array and can access the

various CLI commands. Closing the PuTTY window terminates the

connection.

violin login:

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 299 300

Pas de commentaire

HP VMA-series Memory Arrays Manuel d'utilisateur Page 59