HP 4000S Guide de l'utilisateur télécharger pdf (Page 41)

Basic Administrative Procedures and Setup Completion

41NAS 4000s and 9000s Administration Guide

Adding and Configuring NICs in a Team

Before a NIC is teamed, verify the following:

■ The NICs must be on the same network.

■ The NICs must be DHCP enabled and the DNS server address must be left blank.

Note: The teaming utility becomes unstable if static IP addresses, subnets, and DNS addresses are

set before teaming.

■ Duplex and speed settings must be set to use the default values.

To team the NICs:

1. Open the HP Network Teaming utility. The Network Teaming and Configuration

Properties dialog box is displayed. The type of NIC and the slot and port used is shown.

Figure 16: HP Network Teaming Properties dialog box

2. Highlight the NICs to team.

3. Click the Team button. The Teaming Controls tab of the Properties dialog box is

displayed.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 245 246

Pas de commentaire

HP 4000S Guide de l'utilisateur Page 41