HP 4000S Guide de l'utilisateur télécharger pdf (Page 81)

Disk Management

81NAS 4000s and 9000s Administration Guide

8. Click Save to update the configuration.

9. Close the ACU.

To extend a LUN where space is not available in the array (MSA1000 only):

1. Add an unassigned physical disk to the array using the ACU. If an unassigned physical

disk is unavailable, add a new disk to the appropriate storage device and select Refresh.

2. To add an unassigned physical disk to the array use the following steps:

a. Select the appropriate array controller and the appropriate array that the logical drive

is contained in.

b. Select Expand Array.

c. Select the appropriate physical disk and click OK. The array is expanded.

3. Follow the instructions for extending a LUN.

Extending a partition on a basic disk

Partitions can be extended using either the WebUI extend function from the Managed Volumes

page extend selection or by using the DiskPart command line utility. The Windows Disk

Manager cannot extend basic disk partitions. To extend a partition using the WebUI follow the

steps below:

1. Click the Disks tab.

2. Click the Volumes tab.

3. Click Manage.

4. Select the Volume to extend and click Extend.

Note: If you receive a message that there is not enough disk space to extend the volume, it is

possible to convert the disk to dynamic, provided that there are other dynamic disks with space

available and that the NAS device is not a node in a cluster. The volume can then be extended over

a set of dynamic disks.

5. The page in Figure 42 is displayed. Enter in the amount to extend the partition.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 245 246

Pas de commentaire

HP 4000S Guide de l'utilisateur Page 81