HP 4000M Manuel d'utilisateur Page 79

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 304
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 78
6-3
Configuring the Switch
Overview
Configuring the Switch
Note In the factory default configuration, the Spanning Tree Protocol (STP—which
automatically blocks redundant links) is disabled. Generally, you should
enable STP to prevent broadcast storms if there are redundant links in your
network that are not part of a switch mesh. However, due to the requirements
of the 802.1Q VLAN standard, STP blocks unmeshed redundant physical links
even if they are in separate VLANs. This could result in blocking links unnec-
essarily. Switch meshing can allow use of STP without the problem of blocking
links that could remain open. For more information, refer to “Load Balancing:
Switch Meshing” on page 6-80, and “Spanning Tree Protocol” on page 6-39.
Vue de la page 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 303 304

Commentaires sur ces manuels

Pas de commentaire