HP D2D2502i Manuel d'utilisateur télécharger pdf (Page 130)

Cannot authenticate an iSCSI session

CHAP authentication is used within HP D2D. For details of the settings on the Microsoft iSCSI

initiator and the HP D2D Web Management Interface, see also the HP StoreOnce Backup System

Installation and Configuration Guide.

Diagnostic Fibre Channel device

For each FC port there will be a Diagnostic Fibre Channel Device presented to the Fabric. There

will be one per active FC physical port; this means there are wo ports for an HP D2D4112, 4312

or 4324 appliance.

The Diagnostic Fibre Channel device can be identified by the following example text:

Symbolic Port Name "HP D2D S/N-CZJ1440JBS HP D2DBS Diagnostic Fibre Channel

S/N-MY5040204H Port-1"

Symbolic Node Name "HP D2D S/N-CZJ1440JBS HP D2DBS Diagnostic Fibre Channel

S/N-MY5040204H"

A virtual driver or loader would be identified by the following example text:

Symbolic Port Name "HP D2D S/N-CZJ1440JBS HP Ultrium 4-SCSI Fibre Channel

S/N-CZJ1440JC5 Port-0"

Symbolic Node Name "HP D2D S/N-CZJ1440JBS HP Ultrium 4-SCSI Fibre Channel

S/N-CZJ1440JC5"

In the above the S/N-CZJ1440JBS for all devices should be identical. If this is Node Port 1, the

Node Name string will be as above but, if Port 2, the Node Name string will end with “Port-2”.

Often the diagnostic device will be listed above the other virtual devices as it logs in first, ahead

of the virtual devices. The S/N-MY5040204H string is an indication of the QLC HBA’s SN not any

SN of an appliance/node.

At this time these devices are part of the StoreOnce VTL implementation and are not an error or

fault condition. It is recommended that these devices be removed from the switch zone that is also

used for virtual drives and loaders.

If the HP StoreOnce Backup System runs out of disk space

A warning message is generated when the HP StoreOnce Backup System reaches 80% capacity.

Further warnings are generated at 85% and 90% capacity, and then at 1% intervals from 91% to

99%. If capacity reaches 100%, further error messages are generated.

Note that if email and SNMP alerting is configured on the device, the above warnings and errors

will be delivered by these methods, too.

To reduce the risk of system unavailability, HP recommends that you monitor your disk storage

capacity to ensure that storage utilization stays below 80%. Keeping available disk storage capacity

above 20% offers the best backup and deduplication performance. Prior to reaching 80% utilization,

130 Troubleshooting

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 177 178

Pas de commentaire

HP D2D2502i Manuel d'utilisateur Page 130