HP D2D2502i Manuel d'utilisateur télécharger pdf (Page 43)

8. The discovery process adds new machine(s) to the collection of managed systems. To locate

the HP StoreOnce Backup System, enter its IP address in the Search box in the left-hand pane

and click Search.

NOTE: If the discovery process fails, check that the network is working correctly and that

the HP StoreOnce Backup System is online.

Email Alerts (Configuration)

This page is used to set up details of the email servers that will be used to route messages about

the HP StoreOnce Backup System and to specify up to eight email recipients. Messages are

generated if a disk fails or reaches its threshold capacity, if the system reboots, if there are network

problems or if there is a critical hardware failure.

The HP StoreOnce Backup System uses Simple Mail Transfer Protocol (SMTP), which is the

established standard for transferring mail over the internet. Microsoft Exchange has a virtual SMTP

server available which can be used to receive these emails and forward onward if necessary.

UNIX and Linux operating systems have a Sendmail program included. Sendmail uses the SMTP

protocol to receive and, if necessary, forward e-mail messages.

To configure email settings, the HP StoreOnce Backup System must be on the same network as an

SMTP server that it can use.

• Click Edit to make the fields editable. Make changes, as appropriate and click Update.

• Once you have created a recipient's email address, use the Test button to make sure emails

can be sent successfully.

Table 11 Email parameters

This is the IP address of the email server.SMTP Server:

Some email servers require authentication to send email alerts. If required, enter a Username

and a Password here that are valid on the SMTP server entered in the previous box.

Username and

Password:

Email Alerts (Configuration) 43

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 177 178

Pas de commentaire

HP D2D2502i Manuel d'utilisateur Page 43