Hp Insight Management-Software Manuel d'utilisateur télécharger pdf (Page 56)

remove server-port-map

The –remove server-port-map command removes server port network mapping.

NOTE: The –remove server-port-map command cannot be used if the domain setting

vlantagcontrol is set to tunnel. This restriction is lifted for VC Domain Groups running VC

3.30 and later firmware mode.

Syntax

-remove server-port-map –profilename <ProfileName>

-portnumber <portnumber>

[-network <Network Name>]

Parameters

Table 24 Parameter descriptions for –remove iscsi-boot-param

OptionalRequiredDescriptionParameter

xThe name of the profile from

which the server port map is

to be removed.

-profilename

xThe port number for the

server-port-map targeted for

removal.

-portnumber

xThe name of an Ethernet

network on which the

mapping exists.

-network

Output

The function returns the result of the remove operation or a jobid if –nb is specified.

Examples

• Remove server port network mapping with name Rednetwork:

vcemcli -remove server-port-map –profilename MyProfile –portnumber

1 –network RedNetwork

• Remove all the server port network mappings from an Ethernet connection:

vcemcli -remove server-port-map –profilename MyProfile –portnumber

Minimum Required Role Based Security

VCEM Group Operator

Remarks

The job status for the jobid can be obtained by executing VCEMCLI with the –show job command

and providing the associated job ID. For more information see “show job” (page 61).

56 Using VCEM commands

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 95 96

Pas de commentaire

Hp Insight Management-Software Manuel d'utilisateur Page 56