Hp Insight Vulnerability and Patch Manager Software Manuel d'utilisateur télécharger pdf (Page 34)

Installation and configuration 34

Post-installation configuration

1. Log in to HP SIM from an account with administrator privileges.

NOTE: An administrator can add new users and set up existing users to access Vulnerability and

Patch Management Pack. For instructions, see the HP Systems Insight Manager Installation and

Configuration Guide.

IMPORTANT: This configuration step must be completed for Vulnerability and Patch Management

Pack to function properly.

2. Select Options>Protocol Settings>Global Protocol Settings, and configure the WBEM credentials

to enable access to target systems using one of the following options.

○ Configure settings for the \user account if Vulnerability and Patch Management Pack is

located on the HP SIM server

○ Configure settings for the DOMAIN\user account if Vulnerability and Patch Management

Pack is on a separate server.

3. Enter the Windows administrator account credentials in the Default 1 field and Red Hat

administrator group credentials in the Default 2 field. For systems with individual settings,

configure WBEM credentials using the System Protocol Settings. For information, see the

“Troubleshooting” section.

4. Click OK.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 109 110

Pas de commentaire

Hp Insight Vulnerability and Patch Manager Software Manuel d'utilisateur Page 34