Hp OneView for Red Hat Enterprise Virtualization Manuel d'utilisateur télécharger pdf (Page 9)

2 Installation and discovery

Prerequisites for installing HP Insight Control for RHEV

The following are prerequisites for installing HP Insight Control for RHEV:

• RHEV-M must be installed and configured. Refer to Red Hat's documentation for installation

and configuration of RHEV-M.

• The RHEV-M credentials used during configuration of RHEV-M will be needed.

• The postgres password used during configuration of RHEV-M may be needed, depending on

the authentication method selected for postgres (“pg_hba.conf”).

• The RHEV-M reports package must be installed in order for the reporting functionality in HP

Insight Control for RHEV to be installed and available.

• The net-snmp package must be installed in order to communicate with dependent module

HP common services.

Installing and configuring HP Insight Control for RHEV

NOTE: The following installation procedures apply to both new installs as well as upgrades from

a previous version of HP Insight Control for RHEV.

You must ensure that HP Insight Control for RHEV is installed on the (RHEV-M) management console.

To install HP Insight Control for RHEV:

1. Unpack and install the HP Insight Control for RHEV packages:

[root@rhevm ~]# tar zxf hp-icrhev-x.x.x.x.tar.gz

[root@rhevm ~]# rpm -ivh hpcs-x.x.x.x-1.x86_64.rpm

hpicrhev-x.x.x.x-1.x86_64.rpm

NOTE: The “U” option is required for an upgrade installation:

[root@rhevm ~]# tar zxf hp-icrhev-x.x.x.x.tar.gz

[root@rhevm ~]# rpm -Uvh hpcs-x.x.x.x-1.x86_64.rpm

hpicrhev-x.x.x.x-1.x86_64.rpm

Installing and configuring HP Insight Control for RHEV 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 41 42

Pas de commentaire

Hp OneView for Red Hat Enterprise Virtualization Manuel d'utilisateur Page 9