HP PROCURVE 3400CL-24G Manuel d'utilisateur télécharger pdf (Page 48)

Enhancements

Releases M.08.90 and M.08.91 Enhancements

Figure 11. Using the show run Command to View the Current Authentication MIB Access State

Releases M.08.90 and M.08.91 Enhancements

■ The MSTP enhancement implementing the CLI command for spanning-tree legacy-path-cost

was included in releaseM.08.90

■ The MSTP enhancement implementing the CLI command for spanning-tree legacy-mode

was included in release M.08.91

■ QoS Pass-Through Mode enhancement, a new command that allows the configuration of the

Quality of Service (QoS) queues to be selected.

MSTP Default Path Cost Controls

Summary: 802.1D and 802.1t specify different default path-cost values (based on interface speed).

These are used if the user hasn't configured a "custom" path-cost for the interface. The default of this

toggle is to use 802.1t values. The reason one might set this control to 802.1D would be for better

interoperability with legacy 802.1D STP (Spanning Tree Protocol) bridges.

To support legacy STP bridges, the following commands (options) have been added to CLI:

spanning-tree legacy-path-cost - Use 802.1D values for default path-cost

no spanning-tree legacy-path-cost - Use 802.1t values for default path-cost (default setting)

ProCurve(config)# show run

Running configuration:

; J4905A Configuration Editor; Created on release #M.10.05

hostname "ProCurve"

snmp-server mib hpSwitchAuthMIB excluded

ip default-gateway 10.10.24.55

snmp-server community "public" Operator

vlan 1

name "DEFAULT_VLAN"

untagged 1-26

ip address 10.10.24.100 255.255.255.0

exit

password manager

Indicates that SNMP access

to the authentication

configuration MIB

(hpSwitchAuth) is disabled.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 196 197

Pas de commentaire

HP PROCURVE 3400CL-24G Manuel d'utilisateur Page 48