HP Remote Graphics Software (RGS) Manuel d'utilisateur Page 105

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 247
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 104
Figure 4-4 Advanced Settings dialog
The arrows to the right of the Connections box in Figure 4-4 Advanced Settings dialog
on page 89 can be used to change the order of the network interfaces and, therefore, which
network interface will be used by the RGS Sender. In the above example, the RGS Sender will use
Local Area Connection 3 with an IP address of 10.10.42.59.
To establish a connection from the RGS Receiver to the blade workstation, enter a hostname or IP
address in the HP Remote Graphics Receiver box. If you enter a hostname instead of an IP
address, it is possible the hostname will resolve to the IP address of an incorrect network interface.
This could be caused by a number of factors, including how your DHCP and DNS servers are
configured.
If the hostname resolves to the IP address of an incorrect network interface, you can either:
Enter the network interface IP address (instead of hostname) in the HP Remote Graphics
Receiver box.
Reconfigure your DHCP and DNS servers so that the hostname resolves to the IP address of
the correct (first) network interface.
Network Interface binding on the Sender
89
Vue de la page 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 246 247

Commentaires sur ces manuels

Pas de commentaire