HP Remote Graphics Software (RGS) Manuel d'utilisateur télécharger pdf (Page 31)

Installing the RGS Receiver on Linux

NOTE: The Linux RGS Receiver is available in both 32-bit and 64-bit versions. The Xlib version 1.1.5 is not

supported.

RGS only supports multi-head displays on Linux systems that have NVIDIA cards in TwinView mode. ATI dual-

head is not supported.

To install the RGS Receiver on Linux:

1. Log in as root.

2. Go to the directory where you downloaded RGS, and navigate to the directory lin32/receiver (32-

bit version) or lin64/receiver (64-bit version).

3. Execute the following command:

./install.sh

The RGS Receiver will be installed into /opt/hpremote/rgreceiver.

4. You may be prompted to configure proxy settings. If you access the Internet through a proxy server,

these settings are required to activate advanced RGS features such as Advanced Video Compression and

HP Velocity.

IMPORTANT: The activation process uses anonymous access, so you must add the IP address

192.151.30.9 to your proxy server's list of allowed anonymous access.

NOTE: If the Linux operating system already has proxy settings configured, it will be suggested to use

the settings from the operating system.

5. Optionally, add the directory /opt/hpremote/rgreceiver to your PATH environment variable.

RGS Receiver audio requirements on Linux

The RGS Receiver installer will install a version of JACK Audio Connection Kit if one is not already installed on

the system. JACK is a low-latency sound server that works in conjunction with an ALSA sound driver to mix

and direct audio on the RGS Receiver system. The version of JACK provided with the RGS Receiver installer is

the version that is expected to be started by the script in /opt/hpremote/rgreceiver/hprgsaudio. A different

version may require adjustments to this script to provide different options for the JACK daemon.

The JACK Audio Connection Kit is installed as an RPM package. The RGS Receiver will run on systems without

audio hardware, but the RGS Receiver will not run without the libraries provided by the JACK RPM package. If

the RGS Receiver is being removed from the system, JACK can also be removed using the following command:

rpm -e jack-audio-connection-kit

Uninstalling the RGS Receiver on Linux

To uninstall the RGS Receiver on Linux find the name of the RedHat RPM package for the RGS Receiver by

typing the following:

rpm -q -a | grep -i rgreceiver

If the RGS Receiver is installed on the system, you will see rgreceiver_linux_32-5.1-0 or a similar

package. To remove the RGS Receiver's RPM package, become root and type:

rpm -e --allmatches rgreceiver_linux_32

Installing RGS on Linux 19

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 121 122

Pas de commentaire

HP Remote Graphics Software (RGS) Manuel d'utilisateur Page 31