HP Switch 6208M-SX Manuel d'utilisateur télécharger pdf (Page 645)

100

101

Advanced Configuration and Management Guide

5. Enter the VLAN ID that will contain the protocol VLAN in the VLAN ID field.

6. Enter a name for the VLAN in the Protocol_VLAN_Name field.

7. Select the virtual interface from the Router_Interface pulldown list if you configured a virtual interface for

routing into and out of the VLAN.

8. Select the protocol type.

9. Specify the port that are members for the VLAN:

• Select Dynamic Port if you want the port membership to be dynamic. For information, see “Dynamic

Ports” on page 16-9.

• Click the Change Static Members button if you want to configure static ports. For information, see “Static

Ports” on page 16-10.

• Click the Change Exclude Members button if you want to explicitly exclude some ports. For information,

see “Excluded Ports” on page 16-10.

NOTE: All the ports must be members of the port-based VLAN that contains this IP sub-net VLAN. See

“Layer 3 Protocol-Based VLANs” on page 16-3.

10. Click the Add button (if you are adding a new VLAN) or the Modify button (if you are modifying an existing

VLAN) to save the change to the device’s running-config file.

11. Select the Save

link at the bottom of the dialog. Select Yes when prompted to save the configuration change

to the startup-config file on the device’s flash memory.

NOTE: You also can access the dialog for saving configuration changes by clicking on Command in the tree

view, then clicking on

Save to Flash.

16 - 52

1 2 ... 640 641 642 643 644 645 646 647 648 649 650 ... 709 710

Commentaires sur ces manuels

Pas de commentaire

HP Switch 6208M-SX Manuel d'utilisateur Page 645

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel HP Switch 6208M-SX