HP TC3100 Manuel d'utilisateur télécharger pdf (Page 22)

Chapter 3 Hardware Installation and Configuration

1. Locate the 50-pin connector on the HP Server Remote Management Card.

Figure 3-1: Locating the 50-pin Connector

2. Plug the end of the 50-pin ribbon that is labeled “To Card” into the card’s

connector.

3. If additional cable is needed, order HP Part Number P3537-63010.

NOTE The ribbon cable is keyed to prevent incorrect cable

connection.

Installing the HP Server Remote Management

Card in the Server

Install the HP Server Remote Management Card into slot 6 on your server’s

system board. For specific information about installing a PCI card in your server,

refer to the Operations and Maintenance Guide supplied with your server. See

Appendix D, "Technical Specifications," for information about the power

requirements for the HP Server Remote Management Card.

WARNINGS 1. Power down your Server and unplug all connecting cables

before installing your Management Card.

Always disconnect AC power and unplug external connecting

cables from HP Servers before working inside the unit.

Hazardous voltages are present inside the Server that may

persist until the power cords are unplugged, even after the

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 120 121

Pas de commentaire

HP TC3100 Manuel d'utilisateur Page 22