HP TC3100 Manuel d'utilisateur télécharger pdf (Page 84)

Appendix C Installing and Using TFTP

multiple cards, refer to the HP Server Remote Management

Card online help.

1. From the HP Server Remote Management Card software interface, click

the Configuration tab.

2. Then click the Card Info button.

3. In the Card Maintenance section, fill in the IP address of the TFTP server

and the filename of the firmware. The filename you enter should include a

relative path from the base directory.

4. Ensure the TFTP server is running.

5. To start the firmware update, click Update.

For example, if the TFTP server used \tftp\public as its root and the firmware

image file is named

\tftp\public\hp\fw\ttrc\us\ttrc_rom.bin

you would enter the file name as:

hp\fw\ttrc\us\ttrc_rom.bin

An update can also be performed using a firmware image file and TFTP server at

a remote client (see Figure C-1).

NOTE HP recommends that you do not update the HP Server Remote

Management Card firmware if the link between the TFTP

server and the HP Server is a dial-up network connection. A

disconnection during an update can leave the HP Server

Remote Management Card partially updated and you would

need to repeat the update before proceeding.

A firmware update takes approximately one minute over a 10Base-T LAN

connection. After the update has completed, the HP Server Remote Management

Card will be reset in order to start the new firmware.

Using the HP Server Remote Management Card Remote Boot

Feature

You can use the HP Server Remote Management Card to remotely boot the

HP Server in which you have installed the HP Server Remote Management Card.

The card boots the HP Server using a boot floppy image located on a TFTP

server.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 120 121

Pas de commentaire

HP TC3100 Manuel d'utilisateur Page 84