Hp D6000 Disk Enclosure Manuel d'utilisateur télécharger pdf (Page 19)

Setup 19

• A RAID 1 mirror requires an even number of hard drives.

• Drives that will be configured within an array should be the same capacity to provide the greatest

storage space efficiency.

NOTE: ACU does not support mixing SAS and SATA drives in the same logical volume.

To install the drives:

1. Be sure all I/O bays contain either an I/O module or an I/O blank. The hard drive drawer does not

open if I/O bays are empty.

2. Be sure the I/O modules or I/O blanks are fully seated and their handles are in the locked position. The

hard drive drawer does not open if I/O modules or I/O blanks are not fully seated with their handles

in the locked position.

WARNING: TIP HAZARD! To reduce the risk of personal injury or damage to the equipment, do

not extend the hard drive drawers beyond the supporting surface when the unit is not installed in

a rack.

WARNING: To reduce the risk of personal injury or damage to the equipment, ensure that only

one hard drive drawer is extended at a time.

3. Extend the hard drive drawer.

WARNING: Pinch hazard—Keep hands out of front and rear of chassis when closing hard drive

drawers.

CAUTION: To prevent improper cooling and thermal damage, do not operate the D6000 for an

extended period of time with the drawer open.

CAUTION: To prevent improper cooling and thermal damage, do not operate the D6000 unless

all bays are populated with either a component or a blank.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 52 53

...... 27 May 2025 | 17:27:52

......

Hp D6000 Disk Enclosure Manuel d'utilisateur Page 19