Hp D6000 Disk Enclosure Manuel d'utilisateur télécharger pdf (Page 22)

Setup 22

To remove the I/O blank, release the I/O blank handle, pull the I/O blank handle down until it ejects

the I/O blank, and then remove the I/O blank from the enclosure.

3. To install the I/O module, insert the I/O module into the enclosure and push the I/O module handle up.

Be sure the I/O module is seated fully, and the I/O module handle is in the locked position.

The installation installation is complete.

To install the second I/O module in the other enclosure drawer, repeat the procedure.

CAUTION: For best cooling practices, do not operate the enclosure for extended periods with

more than one component or blank removed. When removing an active component, replace it

with a blank.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 52 53

...... 27 May 2025 | 17:27:52

......

Hp D6000 Disk Enclosure Manuel d'utilisateur Page 22