Hp Hitachi Dynamic Link Manager Software Manuel d'utilisateur Page 102

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 510
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 101
3. Creating an HDLM Environment
80
described in the following sub-sections on all hosts that comprise the cluster.
(1) Perform Operations for HDLM Management-Target Devices
If you have already defined physical volumes and have been running the HDLM
management-target devices, perform the following procedure:
1. Terminate the processes of all applications that are accessing the HDLM
management-target devices.
2. If necessary, back up all HDLM management-target devices to a medium such as
tape.
3. Unmount the disks.
If the HDLM management-target devices are mounted, unmount them as follows:
First, execute the command below to check the current settings.
# mount -p
The current settings will be output as shown in Figure 3-2: Execution
Result Example of the Mount -p Command (Preparations for a New
Installation of HDLM).
Figure 3-2: Execution Result Example of the Mount -p Command (Preparations
for a New Installation of HDLM)
The following example manages the device, which is shown in the shaded
portion of Figure 3-2: Execution Result Example of the Mount -p Command
(Preparations for a New Installation of HDLM), by using HDLM.
Execute the following command to unmount the disk.
# umount /mntpt
4. Execute the following command to inactivate the applicable volume group:
# varyoffvg volume-group-name
Vue de la page 101
1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 509 510

Commentaires sur ces manuels

Pas de commentaire