Hp Hitachi Dynamic Link Manager Software Manuel d'utilisateur Page 118

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 510
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 117
3. Creating an HDLM Environment
96
When using HDLM in a cluster configuration, make sure to perform the operations
described in the following sub-sections on all hosts that comprise the cluster.
(1) Stop Applications
HDLM manager stops during an upgrade installation or re-installation, so stop any
applications that require HDLM manager operations before you start the upgrade
installation or re-installation.
(2) Perform Operations for HDLM Management-Target Device
1. Terminate the processes of all applications that are accessing the HDLM
management-target devices.
2. If necessary, back up all HDLM management-target devices to a medium such as
tape.
3. Unmount the disks.
If the HDLM management-target devices are mounted, unmount them as follows:
First, execute the command below to check the current settings.
# mount -p
The current settings will be output as shown in Figure 3-3: Example of
Results from Executing the Mount -p Command (Preparations for an
Upgrade Installation or Re-installation of HDLM).
Figure 3-3: Example of Results from Executing the Mount -p Command
(Preparations for an Upgrade Installation or Re-installation of HDLM)
This example uses HDLM to manage the devices that are shaded in
Figure 3-3: Example of Results from Executing the Mount -p Command
(Preparations for an Upgrade Installation or Re-installation of HDLM).
Execute the following command to unmount the disk.
# umount /mntpt
4. Execute the following command to inactivate the applicable volume group:
Vue de la page 117
1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 509 510

Commentaires sur ces manuels

Pas de commentaire