Hp MPX200 Multifunction Router Manuel d'utilisateur télécharger pdf (Page 60)

The default is the current setting on the router.

Specifies the SNMP trap version.-trap_version=

Values are 1, 2, or 3.

The default is the current setting on the router.

Example

c:\> rcli set snmp -location="Server Room" [email protected]

-auth_enable=n -trap_index=0 -trap_enable=yes -trap_ipaddr=10.0.0.10

-trap_port=1026 /ip=10.0.0.12

SNMP -trap_index=0 successfully configured

set system

The set system command sets global control and display items for the router, including symbolic

name, enable or disable controller LUN automatic mapping, LUN mapping, and target presentation

mode.

IMPORTANT: You must reboot the router after issuing this command.

Syntax

set system

Keywords

Specifies whether automatic LUN mapping is enabled or disabled for the controller.

Values are:

-controller_lun_automap=

• yes

• no

• on

• off

• true

• false

The default is the current setting on the router.

Specifies whether FTP is enabled or disabled for the router. Values are:-ftp=

• yes

• no

• on

• off

• true

• false

The default is the current setting on the router.

NOTE: This keyword requires router firmware Version 3.2.0.0 or later.

Specifies whether LUN mapping is enabled or disabled for the router. Values are:-lun_mapping=

• yes

• no

• on

• off

60 Command reference

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 119 120

Pas de commentaire

Hp MPX200 Multifunction Router Manuel d'utilisateur Page 60