Hp MPX200 Multifunction Router Manuel d'utilisateur télécharger pdf (Page 138)

A–Simple Network Management Protocol

SNMP Parameters

A-2 ISR654602-00 H

SNMP Parameters

You can set the SNMP properties using SANsurfer Router Manager or the

command line interface (CLI).

Table A-1 describes the SNMP parameters.

Table A-1. SNMP Parameters

Parameter Description

Read community A password that authorizes an SNMP management server to read information

from the router. This is a write-only field. The value on the router and the SNMP

management server must be the same. The read community password can be

up to 32 characters, excluding the number sign (#), semicolon (;), and comma

(,). The default password is private.

Trap community A password that authorizes an SNMP management server to receive traps. This

is a write-only field. The value on the router and the SNMP management server

must be the same. The trap community password can be up to 32 characters,

excluding the number sign (#), semicolon (;), and comma (,). The default pass-

word is private.

System location Specifies the name of the router location. The name can be up to 64 characters,

excluding the number sign (#), semicolon (;), and comma (,). The default is

undefined.

System contact Specifies the name of the person to be contacted to respond to trap events. The

name can be up to 64 characters, excluding the number sign (#), semicolon (;),

and comma (,). The default is undefined.

Authentication

traps

Enables or disables the generation of traps in response to authentication fail-

ures. The default is disabled.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 219 220

Pas de commentaire

Hp MPX200 Multifunction Router Manuel d'utilisateur Page 138