Hp RDX Removable Disk Backup System Manuel d'utilisateur télécharger pdf (Page 19)

Mounting hardw

are used (HP ProLiant)

Ensure that you use the correct mounting rails or locating screws, as described in

“Attach mounting hardware” on page 14. The server also incorporates a locking mechanism to hold

the R DX Remova

ble Disk Backup System in place.

1. Push the server latch down to lock the drive into position.

2. Ensure blanking plates are in place over empt y bays and replace the cover on the server.

No mounting hardware used

1. Use the M3 screws provided with the server. Check that the holes in the chassis are aligned with

the holes in the sides of the drive and use a regular Phillips screwdriver to secure the M3 screws,

as shown in Figure 8 on page 19.

1. M3 screws, supplied

Figure 8 S ecur ing drive, no moun t ing hardware used

2. Ensure blanking plates are in place over empt y bays and replace the cover on the server.

RDX Removable Disk Backup System

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Pas de commentaire

Hp RDX Removable Disk Backup System Manuel d'utilisateur Page 19