Hp Storage Mirroring V4.5 Software Manuel d'utilisateur télécharger pdf (Page 71)

6 - 1

Protecting a File

Server

To configure protection for your file servers using Application Manager, you will complete the

following steps:

1. Install Storage Mirroring on the source and target file servers. See the Storage Mirroring Getting

Started guide for more information.

2. Install the Application Manager on page 2-1

3. Select a task on page 6-1

4. Select a domain on page 6-2

5. Select source and target servers on page 6-3

6. (Optional) Configure protection settings on page 6-5

7. Validate the Configuration on page 9-1

To protect your file server, you will complete the following steps:

1. Enable protection on page 10-1

2. Monitor protection status on page 10-2

In the event of a failure, you will need to perform some additional tasks. These tasks are described

in Failover, Failback, and Restoration on page 11-1.

Select a task

To protect a File server, open the Application Manager (Start, Programs, Storage Mirroring,

Application Manager), then on the Tasks area on the left pane, select Protect File Server. The

Manage File Server page will appear in the right pane. Make sure that the Setup tab is in view.

NOTE: You can also launch Application Manager for File Servers by using the command line

/fileprint option (dtam /fileprint).

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 162 163

Pas de commentaire

Hp Storage Mirroring V4.5 Software Manuel d'utilisateur Page 71