Hp StorageWorks 1510i Modular Smart Array Manuel d'utilisateur télécharger pdf (Page 23)

iSNS enabled

• To manually add iSNS servers

a. Use the set isns command to change the iSNS server discovery mode:

CLI> set isns server_discovery=manual

iSNS parameters set.

b. Use the add isns_server command to add the IP address of the iSNS server:

CLI> add isns_server 20.20.20.26

The iSNS server was added successfully.

Alias: isns1

c. Use the set discovery command to enable iSNS discovery on the iSCSI target.

CLI> set discovery target1 isns=enable

iSNS enabled

Enable SLP disc

overy of the iSCSI target

NOTE:

Steps in this section assume that you already have a basic iSCSI setup conﬁgured.

Use the set discovery command to enable SLP discovery on the iSCSI target:

CLI> set discovery target1 slp=enable

SLP enabled

Conﬁgure static management settings

To access the MSA1510i management functionality over a network that does not use DHCP, and on which

your management host cannot access the default zeroconf* IP address, you must set up a static IP address.

1. Conﬁgure management to use a static IP address using the set management command:

CLI> set management dhcp=disable ip=192.168.1.10/255.255.255.0

gateway=192.168.1.1

2. [Optional] If you have not done so already, conﬁgurealoginandpasswordforaccessing

management functionality using the set management_login command:

CLI> set management_login <user_ID><password>

where <user_ID>and<password> are your own unique settings.

3. [Optional] Switch management functionality to a different physical port using the set management

command:

CLI> set management port=MA1

1510i Modular Smart Array Command Line Interface user guide

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 153 154

Pas de commentaire

Hp StorageWorks 1510i Modular Smart Array Manuel d'utilisateur Page 23