Hp StorageWorks 2110 Disk System Manuel d'utilisateur télécharger pdf (Page 20)

HP StorageWorks Disk System 2100 / 211020

2 Prepare the software environment to remove the drive.

See your operating system documentation for instructions and procedures

required to remove a disk module. It may be necessary to unmount file systems

associated with the disk drives installed in the disk system.

3 Unlatch the disk module handle and remove the disk module.

Squeeze the latch to unlock the disk module. Put a finger behind the latch and

pull the disk module out until it disengages from the backplane. Leave it in its

slot for two to three minutes to allow the disk drive to spin down before removing

the disk module from the enclosure.

If you are going to replace the disk module immediately, refer to “Replace a Disk

Module” below.

If you are not going to replace the disk module immediately insert a filler panel

into the open slot to assure the required cooling.

Replace a Disk Module

1 Refer to your operating system documentation for requirements and procedures

for replacing disk modules.

2 Align the replacement disk module with the disk module slot.

3 Slide the disk module into the slot until it engages with the backplane.

4 Press on the locking handle until it locks. You will hear an audible click when the

locking mechanism is fully engaged.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Pas de commentaire

Hp StorageWorks 2110 Disk System Manuel d'utilisateur Page 20